Installation of the rack mount Energy Manager Server

From Bye Bye Standby
Jump to: navigation, search
  1. Do not plug in a keyboard or mouse as the unit is not designed to be used with these devices.
  2. Plug in the network cable only when the unit is sited where it is to go.
  3. Now plug and power up the server.
  4. Use the lower network port on the rear panel for the cat5 lead.
  5. Go to another PC that is connected to the network.
  6. Open IE or other similar browser.
  7. From the forums on the www.byebyestandby.com/forum
  8. Download BBS Viewer version 2 which is in Online Controller viewer topic at the bottom of the page. It is the 2nd of the two.
  9. Extract and get it running.
  10. Type 53009 into the port field and press start
  11. The IP address of the Energy Manager will show up.
  12. Type this number followed by /admin into the browser.
  13. This should bring up a user name and password screen.
  14. Type these in and you have access to the server.
  15. To change the IP address to a static one given go Admin -> Server Functions -> Change IP address.
  16. Now plug the network cable on the rack mount server into the upper network port, not the lower one. The upper port is marked "1"
  17. Before saving the new information CHECK it is correctly entered as getting it wrong will create issues

[edit] Zone Controller Configuration

  1. Plug zone controller into the network
  2. Plug in the power
  3. Far right green light comes on
  4. The far left comes on then goes off 4 times. It is in programming mode looking for a network connection.
  5. Once addressed both far left lights flash quickly and one of the far left lights may stay on. Depending on the clock speed of the controller it may take up to 60 seconds for process.
  6. Go to browser and go Admin -> Controller Functions.
  7. Highlight with the mouse pointer the Enable Controllers
  8. Go to the controller and press the button on the back
  9. The lights should flash quickly
  10. Press the Enable Controllers on the browser
  11. If successful the lights stop flashing on the controller
  12. You should do this within 15 seconds of pressing the button on the back of the controller
  13. This process takes place for each controller you want to add to the system.
  14. To check if you have been successful go to the browser and Management -> Controllers and your newly added controller should show with its IP address and the last digits of the MAC address should tie up with that on the bottom of the controller
  15. If not successful go back through the process again
  16. When siting the controller ensure it is not too close to electrical devices as it may limit its range.
Retrieved from "http://www.byebyestandby.co.uk/wiki/index.php/Installation_of_the_rack_mount_Energy_Manager_Server"
Personal tools